Compare the strength in 40% replacement of copper slag at 7, 28, and 60 days. M. V. Patil, Y.D.Patil [3] investigated on Effects of copper slag as sand replacement in concrete, for this research work, M30 grade concrete was used and tests were conducted for various proportions of copper slag replacement with sand of 0 to in concrete. Mr.
Copper Slag as partial replacement of sand in SFRC and Conventional Concrete and results are compared. Objectives Investigating the developments in mechanical properties of concrete due to addition of hooked end steel fibers and replacement of copper slag with varying percentages of F.A.Strength parameters of steel fiber reinforced
the copper slag to the bitumen mix as a replacement of fine aggregate is higher than 30%and 40%. Please See Figure-2. As the bitumen content increases the flow value increases. The bulk density increases with the addition of copper slag to the mix due to the fact that the specific gravity of copper slag
Global Enterprises. We are Global Enterprises based in Mumbra, India. member of Tradekey.com since June, 2007. Our business is related to three division1.Mineral product such as CAlcite, donomite, silica sand, copper slag, decorative chips.2.Makers ... Address:Tanwar nagar, Mumbra, maharashtra, India Business type:Exporters.
Today I'm going to be shared about "Project Report on Copper Slag in Concrete" With advantages and disadvantages of copper slag in concrete so let's get started. Introduction Traditionally soil, stone aggregates, sand, bitumen, cement etc. are used for road construction.
This study evaluated the performance of semi-dense asphalt mixtures incorporating 50% to 70% RAP and 7.5% and 15% copper slag (CS) as partial replacement of aggregate, to determine the influence ...
The percentage of copper slag used for replacement of river sand are 0, 25, 50 and 75 %. Cement sand mortar joint thickness of 10 and 15 mm. Plaster ability of use of copper slag for partial replacement material for river sand. Use of copper slag as replacement material for river sand in cement concrete (0, 25, 50, 75 and 100 %)
The failure patterns of copper slag and river sand are however found to similar when tested under similar loading conditions and same longitudinal and transverse reinforcement. 7. From the obtained experimental results it is shown that copper slag with replacement in place of river sand showed an improved structural performance.
small scale copper ore crushing machine in zambia; magnetite sand mining in the philippines ... copper slag vibrating screen mining crushing machinery; ... The vibration exciter and the screen box frame of S5X Vibrating Screen use modular structures If there is a need for replacement the modular vibration exciter can be taken down from the ...
Therefore, copper slag is expected The effect of copper slag replacement as fine aggregates on the to have good potential to produce high quality pozzolans. workability and density of high performance concrete is presented Tests to determine specific gravity and water absorption for in Table 2 for different proportions of copper slag.
Copper Slag (CS) is produced as waste from roasting of copper, in which sulphur (as SO 2 ) is eliminated. CS was used as fine aggregate (up to 30%) in the design of bituminous mixes like Bituminous Macadam, Dense Bituminous Macadam. Bituminous Concrete and Semi-Dense Bituminous Concrete. Mechanical properties of mix such as Marshall stability, Indirect Tensile Strength was determined.
Buy high quality Processed Copper Slag Grit by Noor Exports. Supplier from India. Product Id 893564. Help Contact Customer Support; Your Feedback Forgot Password go4WorldBusiness Q&A Korean: 한국 고객을 위한 Call +1-833-752-7161 Call Us. USA +1 ...
50% of copper slag as sand replacement yielded comparable strength with that of the control mix. However, further additions of copper slag caused reduction in the strength due to an increase of the free water content in the mix. Ramzitaha et al.(2011),In this, Various mortar and concrete mixture were prepared with different proportion of copper ...
1.1 Copper Slag as a Sand Replacement:- Copper Slag as a Sand Replacement can be used due to the following reasons: It has a high Compressive strength which is equal to that of Fine Aggregate with similar diameter. Copper Slag is a non-degradable matter; it is creating an environmental problem so when used as a Replacement for ...
of copper slag and sand from 0 to . The result showed that workability increases with increase in percentage of copper slag. Maximum Compressive strength of concrete increased by 34 % at 20% replacement of fine aggregate with copper slag, and up to 80% replacement of copper slag, concrete gain more strength than normal concrete strength.
40–50% copper slag as a sand replacement yielded comparable strength to that of the control mixture. However, addition of more copper slag resulted in strength reduction due to the increase in the free water content in the mix. Also, the results demonstrated that surface water absorption decreased as copper slag content increases up to 50% ...
The fine aggregate (usually Sand preferred) is basically chemically inert materials used for particles smaller than 4.75mm, contains particles in the size range 75µm to 4.75mm, are partially or fully can be replaced by Crushed sand (Manufacture sand), Crusher dust (Quarry dust), Washed bottom ash, Granulated blast furnace slag, Copper slag, etc.
Corpus ID: 112031287. Performance of Copper slag and ferrous slag as partial replacement of sand in Concrete @article{Sudarvizhi2011PerformanceOC, title={Performance of Copper slag and ferrous slag as partial replacement of sand in Concrete}, author={S. Sudarvizhi and R. Ilangovan}, journal={International Journal of Civil and Structural Engineering}, year={2011}, volume={1}, …
This study aimed to investigate the suitability and cost-benefit of using copper tailings as partial replacement of sand in concrete production. The study was motivated by the accumulation and non-use of copper tailings in dams among them tailing dam 25 also known as TD 25 in Kitwe city of the Copperbelt province in Zambia that take up approximately 111 hectares of unused land.,Laboratory ...
Zambia is African largest producer of copper, ... Copper slag as sand replacement The use of copper slag as sand substitution improves the strength and durability characteristics of high strength concrete up to 50% replacement level (Al-Jabri et al., 2009), increased the ...
Brinda. D et al [4] investigated on various corrosion and durability tests on concrete containing copper slag as partial replacement of sand and cement. In this paper, M50 grade concrete was used and the tests were conducted for various proportions of copper slag replacement with sand of 0% to 60%, cement 0% to 20% and combination.
It is recommended that 40 wt% of copper slag can be used as replacement of sand in order to obtain HPC with good properties.6. It should be noted that further research work is needed to explore the effect of copper slag as fine aggregates on the properties of concrete with different cement types, silica fume sources and the degree of fines.
• Plaster ability of use of copper slag for partial replacement material for river sand • Use of copper slag as replacement material for river sand in cement concrete (0, 25, 50, 75 and 100 %) Materials Cement and Copper Slag In the present investigation, ordinary Portland cement of 53 grade was used. Fine aggregate used for control mortar ...
The percentage replacement of sand by granulated copper slag where 0%, 5%, 10%, 15%, 20%, 30%, 40% and 50%. The compressive strength was observed to increase by about 35-40% and split tensile strength by 30-35%. The experimental investigation showed that percentage replacement of sand by copper slag shall be up to 40%. 11.
Performance of Copper slag and ferrous slag as partial replacement of sand in Concrete. Sudarvizhi S. Meenakshi 1, *, Ilangovan R. 2. 1 Assistant Professor, K.L.N.College of Information Technology, Sivagangai Dist. 2 Assistant Professor, Anna University, Tiruchirappalli, Tamilnadu *Email: [email protected]. Online published on 7 February ...
Investigating the suitability and cost-benefit of copper tailings as partial replacement of sand in concrete in Zambia: An exploratory study. Abstract . Purpose: - This . study investigated the suitability and -benefit costof using copper tailings as partial replacement of sand in concrete production. The study was motivated by the accumulation ...
Copper Slag: Copper slag which is an industrial waste generates from smelting and refining process of copper from Industry. Copper slag is mixed in the concrete as replacement material of fine aggregate. It is the waste product of copper produces from iron or steel plants. IV. Experimental Procedure . The estimation of concrete with copper ...
This paper reports on an experimental program to investigate the effect of using copper slag as a replacement of sand and cement on the properties of conventional concrete. Test performed include moisture content, specific gravity, water absorption and compressive strength.